IP Plan Implementation on NEC IPASO Equipment

1): Connect Laptop with PNMTj software with LCT port of Control card:

 2): Open PNMTj software with username “admin”, connection type “Dial Up” & Dialup Entry Name “PNMT (USB):

 

3): On clicking “Login”, following window will appear:

 

4): First go to “MAINT” and turn on maintenance, then click “CTRL”, following window will appear:

 

5): Click “Equipment Network Setting”, following window will appear:

 

6): Open provided IP Plan. A sample IP Plan is shown below:

7): In Access network MW IP Plan, CTRL type is either “Root NE” or “NE”. Select CTRL Type of your link as per IP Plan.

8): If you select “NE”, then you will have to enter “In Band IP”, “In Band Subnet Mask” & “In Band Default Gateway”. Click “Radio/EM1/EM2 and enter “In Band IP” & “In Band Subnet Mask” at these locations:

 

9): Click “Routing” and enter “In-Band Default Gateway” there as shown:

 

10): If your node is “Root NE”, select “CTRL Type” as “Root NE”, as shown:

11): Click “Radio/EM2” and enter “In-Band IP” & “In-Band Subnet Mask” there, as shown:

 

12): Click “PNMS(EM1)” and enter “North Bound IP address” & “North bound Subnet Mask” there:

 

13):  Click “Routing” and enter “North bound Default Gateway” there as shown:

 

14): Do not forget to “Execute” each time you enter new entries. After entering all these entries, go to “CTRL” tab and click “CPU Reset”

NOTE
Resetting the Control module will not affect traffic. The connection to the selected NE will be lost for a few minutes but will be automatically restored.